My 350z's

Over the years I have owned 2 350Zs, a 2003 Enthusiast and a 2004 Enthusiast. I have autocrossed both of these, and have quite a few blog posts, photos, and videos that you can choose from.

Installing the 350z Trailer Hitch

So the time finally came, or I finally got around to it, the hitch is now on our 2004 Nissan 350z.

The hitch is a Curt Hitch for the 350z, available via Amazon. I purchased it quite a while ago, but haven’t taken the time to get the car apart and install it. Today that all changed.

To get the hitch on the car, you first have to remove the rear bumper fascia from the car, that’s fairly simple to do, remove the rear tail lights, remove 6 or so screws, 4 clips, and pull. The 350z Service Manual is helpful for this.

After that you have to go ahead and drill some holes in the bumper. The hitch itself uses 4 bolts, but the instructions call for cutting a fifth hole, to access to make fishing in the bolts and washer plates.

We spent quite a bit of time trying to avoid cutting the access hole, trust me, just cut it, don’t go through the pain of trying to make it work without. I also recommend that you get a long magnetic puller tool, something that extends like an old conference room pointer, with a magnet on the end, it will make things easier to access within the aluminum bumper of the 350z.

Other helpful steps, get a couple of extra washers, there is no way, in my opinion, that the Curt Hitch can work with the two washers included, you need at least 4 (we got 6 extra, used 4 total).

Part of the biggest pain in doing the installation of the Hitch were the two clips that hold the bumper fascia on just outside/below the tail lights. They are hard to access due to the layout of the car, I was able to finally get them off using an 8mm wrench, though it took a lot of cursing. Installation of these was even worse, here’s my advise. Take the clips out of the body of the car, put them onto the fascia, then put them back into the car when the bumper goes back on. Be careful not to break them.

So the hitch is on the car, though I don’t plan to use it for a good couple of weeks at least. I don’t have a trailer yet, it will likely just be used so that I can take a bike to/from work so I can ride at lunch.

Here is a during, and after photo, and stay tuned for the time lapse video of the process later on.

350z Trailer Hitch Installed Now that @project350z is apart, time to find the hitch in the garage

Recent Comments

There are currently no comments. Be the first to make a comment.

Add Comment

Please add your comment by filling out the field(s) below. Your comment may need to be approved before it becomes visible.
Enter your first name for display with the comment
Enter your last name for display with the comment.
Enter your email address so that we may contact you if necessary. We will also use this for your Gravatar.
Enter the URL to your website. URLs may be removed from comments.
Enter your comment here.
If you can't type Human2 in, you can't post, plain and simple.
Submit Comment Cancel
Chris Hammond

Chris Hammond is a father, husband, leader, developer, photographer and car guy. Chris has long specialized in ASP.NET and DotNetNuke (DNN) development, so you will find a variety of posts relating to those topics. For more information check out the about me page.

If you are looking for DotNetNuke consulting please visit my business website at https://www.christoc.com/

Find me on Twitter, GitHub and LinkedIn.